Dumas Aeronca C-3 Kit 40"

Tower Stock# LXPCA6  •  Manufacturer Stock# 1813
Dumas Aeronca C-3 Kit 40
Notes from our tech department:
This is the radio controlled, electric powered
Dumas Aeronca C-3 Park Flyer Kit.


Construction: Hand selected laser cut balsa
Vacuum molded nose cowl
Rudder Control: Pull-pull cables
Elevator Control: Wire pushrod
Servo Placement: Mounted in rails on fuselage
Landing Gear: 1/16" diameter wire front, .041 diameter wire rear,
requires bending


All balsa, lightweight colored (black and yellow) tissue covering
two 1-3/4" (45mm) lightweight foam main wheels, CA hinges and all
hardware to complete this kit, instruction manual, two full-size
plan sheets, and acetate sheet for windows


GWS IPS (indoor power system) motor with "A" ratio gear drive
3 channel radio system (minimum)
2 micro servos
2 cell 700mAh LiPo battery
GWS 8x6 prop
Building and field equipment


Length: 22" (559mm)
Wingspan: 40" (1016mm)
Wing Area: 329 sq.in. (21.25 sq dm)
Airfoil: Flat bottom, high wing placement
Center of Gravity (CG): 2.5" (63mm) back from the leading edge of the
wing at the fuselage side
Control Throws-
Elevator, Up and Down: 3/4" (19mm)
Rudder, Left and Right: 1" (25mm)


Know Before You Fly
Easy RC: Airplanes
Manufacturer Mailing Address
Additional Manufacturer Contact Info