Tekin RSX ESC 5.5 Gen3 Sensored BL Motor System

Tower Stock# TEKC2753  •  Manufacturer Stock# TT2753
Tekin RSX ESC 5.5 Gen3 Sensored BL Motor System (large view)
Notes from our tech department:
This is the Tekin RSX Sensored/Sensorless Electronic Speed Control,
and the Redline GEN3 5.5 Turn Brushless Sensored Motor.


Operates brushed or brushless, sensored or sensorless motors
LiPo safe with custom voltage cutoffs
HotWire PC programming port (Hotwire not included & must be purchased
separately, TEKM1451)
Datalogging capability
D2 Dual Drive Mode technology
On-board temperature indicator
Sensor plug for precise commutation with all motors
High speed fan for maximum cooling
Programming features include;
High voltage 6.0/7.4V BEC (battery eliminator circuit)
13 step drag brake/brake/reverse strength
Current limiter (none + 12 steps)
Neutral width (13 steps)
Timing Profiles (5 preset - 2 custom)*
Adjustable throttle and brake minimums
Custom throttle curves
Motor/Reverse Type: Brushless, Brushed, No Rev, Rev Delay
Voltage cutoffs (none, 2S, 3S, Custom)
Timing Boost and Turbo when used with Hotwire
ROAR Race Spec "Blinky" Mode
Save, Load and Share data log and custom ESC setup files*
*Requires Hotwire (sold separately)

Redline GEN3 5.5 Turn Motor, TEKC2713
CNC machined T 6061 billet aluminum heat sink can
For on- or off-road use
12.5mm performance rotor
Dual-plug sensor wire harness for all sensored and sensorless systems
Anodized end-bell plates maximize corrosion and wear resistance
High RPM precision ball bearings
Neodymium sintered magnet
Adjustable timing
Low resistance solder tabs
Solderless sensor PCB replacement


RSX ESC with Fan, two Zip Ties, Capacitor, 12AWG Motor Wires, On/Off
Switch, Receiver Connector and Instructions
Redline GEN3 5.5 Turn Brushless Sensored Motor with Sensor Wire


Input Voltage: 4-9 Cells, 2S-3S LiPo
BEC: 6.0V/7.4V, 5.5amps
Motor Limit Brushless Mode 2S: 2.5 Turn 2-pole, 4lb chassis
Motor Limit Brushless Mode 3S: 8.5 Turn 2-pole, 4lb chassis
Motor Limit Brushed 2S: 6 Turn, 36mm Can
Motor Limit Brushed 3S: 12 Turn, 36mm Can
Max Current: 180amps per phase
Timing Profiles: 7 choices (on board)
Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay
Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay
Dimensions: 1.22 x 1.46 x .82" (31.2 x 37.2 x 21mm)
Weight: 1.5oz (42g)
6.5T Motor;
Input Voltage: 2S all, 3S-10.5 and up
Shaft Dimensions: 3.2mm (1/8") x 15.3mm
Weight: 5.6oz (158g)
Motor Diameter: 1.40" (35.85mm)
Motor Length: 1.9" (48.5mm)
Bearing Dimensions: Front: 4x13x5mm / Rear: 1/8x3/8x5/32"

jxs 02/22/16


Manufacturer Contact Information