This is the Easy Start Starting System for Traxxas Nitro Vehicles|
using the Traxxas TRX and TRX PRO Engines such as
NITRO SPORT, NITRO RUSTLER, NITRO STAMPEDE, AND NITRO VEE.
To install on Nitro Hawk, Nitro Buggy, Nitro Street requires modifications.
*** NOTE: This is NOT designed for use on any other manufacturer's engines ****
Starting your Traxxas nitro vehicle with a push of a button.
One Control box pre-wired w/LED indicator light.
One Wiring Harness
One Preassembled Starter rs380sh motor and gear box.
Five White nylon tie straps
One Hardware bag w/screws, nut, washers, mount, double sided tape.
One Instruction sheet.
6-cell battery w/Tamiya plug, battery charger (peak detection or
15-minute quick charger).
If installing on a Nitro Rustler #4550 header is required.
Starter Conversion: If The Traxxas Engine Already Has A Pull Starter
- Simply Take Remove Pull Starter and Install This Easy Start
System. If The Traxxas Engine Does Not Have A Pull Starter At All-
Purchase: Starter Shaft, Backplate, TRAG4011-One-Way Bearing,
TRAG4013-Gasket and TRAC5552-3x8mm Screws.
NOTES: Per TRAXXAS the rear gear is now metal. And anyone who has stripped
out this plastic rear gear can call them and they will replace it
Because of the size of the tip of the Traxxas glow plugs, the
Easy Start will only work with Traxxas glow plugs. Most other
glow plugs have a tip that is too large for the lead to
connect to without damaging the lead.
updated tjt 1/3/2