Redcat Racing 1/10 Tornado S30 Nitro RTR Blue/Silver

Tower Stock# LXGLPF  •  Manufacturer Stock# TORNADOS30-R107
  • front/side (see larger view)
  • rear/side (see larger view)
  • top (see larger view)
  • bottom (see larger view)
  • out of package (see larger view)
  • packaging (see larger view)
Easy Pay
Request 3 Payments of $63.33 Details
Notes from our tech department:
This is the 1/10 scale 2.4GHz Radio Controlled, Glow Powered
Ready to Run Redcat Racing Tornado S30 Buggy with Blue and Silver Body.

FEATURES

Chassis: 0.098" (2.5mm) thick aluminum
Drive: Four wheel shaft
Transmission: 2-speed with adjustable shift point
Radio: 2.4GHz RCR-2C pistol grip, steering and throttle trim and dual
rate steering
Servos: Hexfly HX-3CP steering and throttle servos with 14.7 oz-in
(3kg-cm) torque
Engine: 3.0cc SH-18 with pull starter, glow plug and foam air filter
Exhaust: Polished aluminum tuned pipe
Suspension: Adjustable pillow ball
Shocks: Oil-filled aluminum body
Shock Towers: Aluminum 0.098" (2.5mm) thick
Brake: Composite disc
Body: Trimmed and painted with black plastic high-downforce wing
Wheels: 5-spoke plastic with chrome finish
Tires: Molded rubber 3.3" (85mm) diameter, front width 1.2" (31mm),
rear width 1.6" (41mm)
Caster: Adjustable caster/toe-in refers to the angle of the
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle

INCLUDES

Prebuilt Tornado S30 Buggy with Blue and Silver Body, 2.4GHz Radio
System, .18 cu in Engine with Pull Starter, Tuned Pipe, Rear Wing
and Instructions

REQUIREMENTS

Fuel: Car blend with 15-30% nitro content, 20% required for break-in
Glow starter, fuel bottle, track and maintenance equipment

SPECIFICATIONS

Vehicle;
Length: 15.7" (400mm)
Width: 9.8" (250mm)
Height: 6.3" (160mm)
Ground Clearance: 1.02" (26mm)
Wheelbase: 10.8" (275mm)
Body;
Length: 12" (302mm)
Width: 7" (178mm)
Height: 2.75" (70mm)
Carburetor Settings;
High-Speed Needle: 2-2-1/2 turns open from fully closed
Low Speed Needle: With engine at idle, pinch fuel line shut, if
engine increases speed for 2-3 seconds then loses speed, carb is
correctly set. If engine loses RPM quickly it is set too lean and
low speed needle must be opened (counterclockwise) to richen
mixture
Idle Stop Screw: Barrel should be approximately 1mm from fully closed

COMMENTS

For Replacement Ball Bearings use:
Qty. Size Location Qty. Stock Number
2 5x10x4mm Diff 1 DTXC1535
2 10x15x4mm Fr Gearbox 1 DTXC1595
2 10x15x4mm Rear Gearbox 1 DTXC1595
Size of wheel hub ball bearings not supplied by manuafacturer

jxs 03/24/17
ir/jxs

Resources
Easy RC: Cars & Trucks
Manufacturer Mailing Address
Additional Manufacturer Contact Info