This is a large scale retractable tailwheel with forked axle for the tailwheel|
and air cylinder. For use with planes upto 40 lbs.
This Unit Comes Pre-Assembled with an Air Cylinder and Tailwheel
Steerable with a Pull-Pull System Attached to the Rudder Servo.
One Retractable Tailwheel wAir Cylinder and Tailwheel Fork Axle
One InstructionParts List Sheet
Pressure Tubing to Reach from the Main Control Unit to the Air Ram
One 2 Tailwheel
Plastic Sleeved Pull-Pull Steel Steering Cables(Goes to Rudder Servo)
Four 6-32 Mounting Screws
Four 6-32 Blind Nuts
Four 38 x 12 Maple Mounting Blocks
Four Dowel Pins (Used to Mount Maple Mounting Blocks to Bulkhead)
Retract Mounting Brace Height: 2-1116 (68.5mm)
Retract Mounting Brace Width: 2
Height from Axle Center to Bottom Retract Brace: 2-18 approx.
Extended Length from Axle Center to Retract Brace Mount: 3-1116
Retracted Length from Axle Center to Retract Brace Mount: 4-18
On the Air Cylinder: Extend Fitting is Located Forward and the
Retract Fitting is Located Aft.
For the Offset Axle Version, use ROBQ2225.