Lumenier LUX V2 Flight Controller (MPU6000)

Tower Stock# LUME1030  •  Manufacturer Stock# LUM6597
Notes from our tech department:

FEATURES

Hardware Features:
USB Conflict resolution - Hardware inversion, SBUS or telemetry can
be used on any of the three available hardware serial ports
MPU interrupt connected to F3, allowing F3 to know immediately when
fresh data is available
Dedicated Boot button for easy firmware flashing
Reinforced solder pads
Integrated FRSky RSSI Filter (RC filter)
Input voltage 6-24V; power board directly from flight pack up to 6S
VIN + VBAT merged - a single wire to power the board provides
voltage input and Telemetry/OSD voltage data
Filtered voltage output - output 5v 1A (3.3v where applicable) to
power peripherals such as GPS, RX, BLACKBOX, OSD. 5V/3.3V RX
selectable

New V2 hardware features include:
Dedicated UART for RC RX use, no need to solder a jumper to select
PPM/SRX
Dedicated telemetry UART, total 5X plus USB
SD Card slot for BlackBox data recording (SD card not included)
Low noise MPU6000 SPI Gyro
USB detection can disable things like buzzer when configuring on
bench
New ultra low noise regulators for MCU and IMU power systems

Software/Hardware Features:
Betaflight support (Supports new DSHOT protocol)
Cleanflight support (RACE target)
BLHeli passthrough flashing supported by hardware
Raceflight ready

INCLUDES

Lumenier LUX V2 Flight Controller
Two 2x7 Straight Pin Headers

SPECIFICATIONS

Dimensions: 1.4 x 1.4 x 0.24" (36 x 36 x 6mm) height includes USB
Mounting Holes: 1.2" (30.5mm) square to center of holes
Weight: 0.18oz (5g)
Input Voltage: 6V - 24V
Processor: 32-bit STM32F303RCT6 (256kB flash)
Gyro/Accelerometer: MPU6000 SPI
Programming Connector: Micro USB

jxs 11/08/18
ir/jxs

Resources

Manufacturer Contact Information