Multiplex Heron High Performance Glider Kit 94.4"

Tower Stock# LXFFEJ  •  Manufacturer Stock# M214276
Multiplex Heron High Performance Glider Kit 94.4
Easy Pay
Request 3 Payments of $48.33 Details
Notes from our tech department:
This is the Radio Controlled, Brushless Electric Powered
Multiplex Heron 2.4M Glider Kit


Construction: Elapor foam, detachable wing and tail sections
Wing: CFRP/aluminum tubular spars, four flap design, detachable for
easy transport
Fuselage: GRP "M" space technology design for high degree of rigidity
Canopy: Clear molded plastic
Spinner: 2.1" (54mm) white plastic
Propeller: 12x6 folding
Landing Gear: Single 1.8" (45mm) diameter rubber wheel


Multiplex Heron 2.4M Glider Kit with Folding Propeller, Spinner,
Decal Sheet and Instructions


Brushless Motor: 36mm length capable of handling 3.3lbs (1550g) such
as the ElectriFly .15 35-36-1200 Brushless Outrunner (GPMG4620)
ESC: 45A if using motor listed above
Radio: 6-channel
Servos: Two micro, elevator and rudder
Four sub-micro, 2-ailerons, 2-flaps
12" Servo Extensions: Four for fuselage
16" Servo Extensions: Two for ailerons
24" Servo Extension: For elevator and rudder
ESC: To match selected motor
Propeller: 12x6 folding
Battery: 3S 2200mAh LiPo
Battery Charger: To match selected battery
Charging bag, building and field equipment


Wingspan: 7.87' (2.4m)
Length: 3.60' (1.09m)
Weight: 2.9lbs (45.87oz) (1350g) glider,
3.3lbs (52.91oz) (1550g) with electrics
Wing Area: 639 sq in (41.3 sq dm)
Wing Loading: 10.72 - 12.3 oz sq in (32.7 - 37.5 g/sq dm)
Center of Gravity (CG:) 2.5" (65mm) back from the leading edge of
wing measured at the fuselage
Control Throws:
Rudder: 0.78" (20mm)
Elevator: 0.39" (10mm), Powermix 0.0196" (0.5mm)
Down elevator mix w/flap speed/ thermic 0.059" (1.5mm)
Ailerons: Up +0.63" (+16mm), Down -0.31" (-8mm)
Flap +0.079/-0.079" (+2/-2mm)

Flaps (camber changing flaps)
Aileron: 0.39" (10mm)
Up (speed) 0.12" (3mm)
Down (thermic) 0.14" (3.5mm)

Spoilers (butterfly)
Both Ailerons Up: 0.87" (22mm)
Both Flaps Down: 1.02" (26mm)
Down-Elevator Mix with Spoiler: 0.196" (5mm)


This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium CA glue used with
an activator is the only method of gluing recommended by the

jxs 04/07/15

Know Before You Fly
Easy RC: Sailplanes
Manufacturer Mailing Address
Additional Manufacturer Contact Info