Phoenix Model Sbach 342 60cc Gas/EP ARF 86.6"

Tower Stock# PMMA1765  •  Manufacturer Stock# PH101
  • front/side (see larger view)
  • rear/side (see larger view)
  • out of package (see larger view)
Shipping Note:$59.99 Surcharge
Easy Pay
Request 3 Payments ($150.01, $149.99, $149.99) Details
Notes from our tech department:
This is the Radio Controlled, 60cc Gasoline or Electric Powered,
Almost Ready to Fly Phoenix Model Sbach 342 scale Aerobatic Airplane.
For Intermediate Pilots.

**Additional Technical Info Will Be Added When It Becomes Available.**


Construction: Laser cut balsa and plywood
Wing: Bolt-on two piece
Aileron Control: Dual servo
Covering: High quality heat shrink covering
Landing Gear: Aluminum main gear, spring wire for tail gear
Canopy: Clear molded plastic, painted pilot figure
Cowl: Painted fiberglass
Fuel Tank:
Spinner: 3.4" (86mm) diameter blue plastic
Warranty Period: 90 day limited warranty


Prebuilt Wing, Fuselage and Tail sections with Landing Gear, Wheels,
Fuel Tank, Spinner, Pilot Figure and Instruction Manual


Radio: 8-channel minimum
Servos: Eight standard size, high-torque 2 aileron; 2 elevator;
1 rudder; 1 throttle (if using glow engine)
Gasoline Power;
Receiver Battery: 3000-4000mAh
Glow starter, fuel
Electric Power;
LiPo Battery: 12 cell (6000-7000mAh)
Electronic Speed Control: 160A/HV
Battery charger

Prop for glow engine or motor, field and maintenance equipment


Wingspan: 86.6" (2200mm)
Length: 82" (2083mm)
Flying Weight: 18.1 - 18.7lbs (8200 - 8500g)
Wing Area: 1489 sq in (96.2 sq dm)
Wing Loading: 27.85oz/sq ft (85g/sq dm)
Servo Mount: 0.83 x 1.6" (21 x 42mm)
Wing Type: Naca airfoils
Center of Gravity (CG): 7.3" (185mm) back from the leading edge of
the wing measured at the fuselage
Control Throws; Low Rate High Rate
Ailerons up/down 0.59" (15mm) 10% expo 0.79" (20mm) 10% expo
Elevator up/down 0.59" (15mm) 12% expo 0.79" (20mm) 12% expo
Rudder right/left 1.6" (40mm) 15% expo 2.4" (60mm) 15% expo

jxs 04/05/16

Know Before You Fly
Easy RC: Airplanes
Manufacturer Mailing Address
Additional Manufacturer Contact Info