Associated 1/10 RC10B6.1D Team 2WD Buggy Kit

Tower Stock# LXHAJW  •  Manufacturer Stock# 90021
  • Thumbnail 1 (see larger view)
  • Thumbnail 2 (see larger view)
  • Thumbnail 3 (see larger view)
  • Thumbnail 5 (see larger view)
Notes from our tech department:
This is the 110 scale Radio Controlled, Electric Powered
RC10B6.1 Team Buggy Kit from Team Associated.

**Includes an all new Lay Back Stealth transmission**
**that adds additional traction when exiting corners.**


Chassis: Constructed of 7075 aluminum, shortened, 0.12 (3mm) thick
Drive: Rear wheel, heavy-duty V2 rear axle with 67mm bones
Transmission: Lay Back Stealth
Differential: Easy access ball type, height adjustment with 0, 1, 2,
and 3mm inserts
Suspension: Gull wing shaped arms for sharp feel and control
rear arm with molded inserts for ultra-fine lower shock mount
adjustment, front and rear anti-roll bars
Steering: +1 Ackermann plates for sharp feel and control, Ackermann
refers to the effect of the inside front wheel turning faster
than the outside front wheel during turns
Shocks: Machined pistons for smoother operation, V2 springs
Shock Towers: Heavy-duty V2 routed graphite, tower guard on front
shock tower, standard height rear tower
Body: JConcepts B6 clear body with wing, molded spur gear guard
protects body from damage
Ball Bearings: Factory Team upgraded ball bearing kit, ball bearings
are oiled instead of greased for less drag
Caster: Adjustable front and rear, castertoe-in refers to the angle
of the front when viewed from the side of the car in relation to
the chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle


RC10B6.1 Team Buggy Kit with Clear Body and Wing, Shocks, Ball
Bearings Lay Back Stealth Transmission and Instruction Manual


Radio: 2-channel with steering servo
Motor: 540 size
Electronic Speed Control: To match selected motor
Battery: 7.4V LiPo or 6.6V LiFe, shorty, saddle or square pack
NOTE, the battery strap must be removed, and battery secured with
double-sided tape if using a saddle or square configuration
Battery Charger: To match selected battery
Pinion Gear: 48 pitch
110 scale buggy wheels and tires
Paint, tire glue, charging bag (if using LiPo batteries) building
and track equipment


Final length, width and weight will vary based on electronics, tire
configuration, wing position and vehicle setup
Wheelbase: 10.91 - 10.98 (277 - 279mm)
Internal Gear Ratio: 2.6:1
Length: 11.9 (302mm)
Width: 4.8 (122mm)
Height: 2.6 (66mm)


For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
4 3x7x3mm Steering 2 DTXC1506
4 5x10x4mm Steering Blocks 2 DTXC1535
4 5x10x4mm Gearbox 2 DTXC1535
2 10x15x4mm Differential 1 DTXC1595
2 10x15x4mm Rear Uprights 1 DTXC1595
2 6x13x5mm Rear Uprights 1 DTXC1573

jxs 020918



Manufacturer Contact Information