Backorder
Brand Logo
5 out of 5 Customer Rating

Currie Portal F9 Rear Axle, Black Anodized: Axial SCX10-II

Item No. VPS08360
Currie Portal F9 Rear Axle, Black Anodized: Axial SCX10-II
Backorder
Brand Logo
5 out of 5 Customer Rating

Currie Portal F9 Rear Axle, Black Anodized: Axial SCX10-II

Item No. VPS08360
$249.99
RC Club points earned on this item shown at checkout.
Only manufacturer discounts can be applied to this product. Tower Hobbies coupon codes not applicable
Back Order
Selected Store
The link to Currie Portal F9 Rear Axle, Black Anodized: Axial SCX10-II has been copied

Product Details

Currie F9 Portal Rear Axle for SCX10-II based vehicles.
Key Features
  • Included Vanquish AR44 Machined Gear Set
  • 13mm Increase In Ground Clearance
  • Complete Fast Eddy Bearings Kit
  • Licensed By Currie Enterprises
  • Uses All SCX10-II Linkage
icon-box
In The Box
  • (1) Currie Portal F9 Rear Axle

Overview

The F9 Portal axles create extreme amounts of ground clearance under the center of your axle, increasing the clearance by 1/2"+ (13mm). This provides the equivalent of a tire over 1 inch taller than what is on your vehicle. The advantage of the Vanquish Currie F9 Portals is the gear reduction inside the portal (1.67:1) which can be adjusted with optional gear sets (1.4:1 Overdrive*). By adding reduction at the portal, less torque is transferred through the other upstream components in the drivetrain. These axles are a direct replacement to any Axial AR44 axle, using all stock links. These axles come with all parts needed to assemble a full rear axle. Requires the use of a 350 SLW hub or greater on Vanquish 1.9 wheels, Incision wheels will require a #4 or greater. Other wheel manufacturers offsets will vary. Axles must be used in pairs, you cannot run a front portal axle without a rear and vice versa. Overdrive gear sets are recommended for use in the front axle only.

Features

  • Portal box integrated into the rear housing for the most clearance at the axle ends possible and a more scale appearance
  • Gear reduction in the portal of 1.67:1 (18/30), Optional Overdrive Ratio* of 1.4:1 (20/28)
  • Included Vanquish AR44 machined gear set
  • Overall axle reduction of 6.26:1 with stock portal ratio
  • 13mm increase in ground clearance
  • Hex to hex width of 7.66 inches, only roughly 5mm wider than a stock AR44 axle with a narrow hex
  • Chromoly inner rear axle shafts are triple bearing supported
  • Chromoly stub shafts with 6mm design at the drive pin which tapers down to a 5mm thread for ultimate strength
  • Aluminum 12mm hex with set screw
  • Uses all SCX10-II linkage
  • Complete Fast Eddy Bearings kit
  • Licensed by Currie Enterprises
  • Comes with One Piece Bearing Retainers (Patent Pending)
  • Double shear shock mounts
  • Upper link mounts built into third member
  • Increased upper link clearance for more suspension up travel ability

Product Specifications

Application Axial SCX10-II
Material Aluminium
Part Type Drivetrain Parts
Scale 1/10