Tamiya 1/10 XB Neo Fighter 2WD RTR

Tower Stock# LXEDMN  •  Manufacturer Stock# 57872
Tamiya 1/10 XB Neo Fighter 2WD RTR (large view)
Notes from our tech department:
This is the 1/10 scale, radio controlled, electric powered,
ready to run XB Neo Fighter Buggy.
For ages 14 and above.


Chassis: DT-03 plastic monocoque
Drive: Rear wheel
Radio System: Tamiya Finespec 2.4GHz pistol grip with steering and
throttle trim and reverse and steering servo
Electronic Speed Control: Tamiya TEU-105BK with reverse (TAMC5055)
Motor: 540 brushed, preinstalled to assembled gearbox
Suspension: Four wheel double wishbone
Differential: Bevel gear
Body; Painted polycarbonate
Driver Figure: Painted plastic
Shocks: Coil over plastic body friction, not oil-filled
Wheels: White plastic star dish design
Tires: Front, grooved
Rear, pin spike
Steering: Direct servo with tie rods
Front Bumper: Spring type to absorb minor impacts
Camber: Non-adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering Tie Rods: Adjustable, caster/toe-in refers to the
angle of the front suspension when viewed from the side of the car
in relation to the chassis


RTR Tamiya Neo Fighter Buggy with brushed motor, ESC, painted body,
Rear Wing, 17T pinion gear, tires, wheels, shocks, decal sheet,
2.4GHz Radio and instruction manual


Battery: 7.2V stick pack with standard connector
Battery Charger: To match selected battery
AA batteries: Four for transmitter
Track and Maintenance equipment


Length: 16" (406mm)
Width: 9-5/8" (245mm) at widest point
Weight: 2lbs 6oz without electronics or battery
Ground Clearance: 1" (25.4mm) w/about 1/2" (12.7mm) adjustability
Length: 11.4" (289mm)
Width: 3.5" (90mm)
Height: 2.5" (64mm)


To Upgrade to Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 5x11mm Rear Uprights 1 DTXC1547
4 5x11mm Front Uprights 2 DTXC1547
8 5x11mm Front Uprights 4 DTXC1547

jxs 02/04/14

Easy RC: Cars & Trucks
Manufacturer Mailing Address
Additional Manufacturer Contact Info