Tekin RSGen2 Spec ESC 17.5 Gen3 Sensor BL Motor System

Tower Stock# LXFREA  •  Manufacturer Stock# TT2743
Tekin RSGen2 Spec ESC 17.5 Gen3 Sensor BL Motor System (large view)
Notes from our tech department:
This is the Tekin RS5 Gen 3 Brushless Sensored 17.5T Motor and the
RS Gen2 Spec Brushless Electronic Speed Control.


TT2705 17.5T Motor (TEKC2705);
CNC machined T 6061 billet aluminum heat sink can
For on- or off-road use
12.5mm performance rotor
Dual-plug sensor wire harness for all sensored and sensorless systems
Anodized end-bell plates maximize corrosion and wear resistance
High RPM precision ball bearings
Neodymium sintered magnet
Adjustable timing
Low resistance solder tabs
Solderless sensor PCB replacement

ESC (TEKC1155);
Compatible with sensored, sensorless, brushless, and brushed motors
Datalogging capability
True ROAR spec mode only, no timing or boost features available
High voltage programmable Battery Eliminator Circuit (BEC)
HotWire PC interface for advanced programming and updating, EZ access
programming port (HotWire 2.0 Interface (TEKM1451), and Gen 2
Adaptor (TEKM3825) required)
Forward, brake, and reverse operation
D2 Dual Drive Mode technology
On-board temperature indicator
Sensor plug for precise commutation with all motors
Gold plated solder posts
Pit tune mode
HDAC: High Density Copper PCB's
Self test diagnostics and factory reset
DGF2 Digital Glitch Filtering V2
QuickTune programming with one-touch radio calibration
120 day limited warranty through Tekin beginning at date of purchase


RS Gen 2 Spec D2 Brushless ESC with Instructions, Motor and Receiver
Redline GEN3 17.5 Turn Brushless Sensored Motor with Sensor Wire


Input Voltage: 4-7 cells NiMH/NiCd, 2S LiPo
BEC: 6.0V / 3.7V
Amperage: 60A per phase
Motor Limit Brushless Mode 2S: 13.5T 2-Pole 36mm Can
Motor Limit Brushed Mode 2S: 20 Turn 36mm Can
Max Chassis Weight: 4lbs (1815g)
Throttle Profiles: 7 choices on-board
Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay
Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay
Dimensions: 1.0 x 1.3 x .51" (26 x 34 x 12.9mm)
Weight: .80oz (22.5g)
17.5T Motor;
Input Voltage: 2S all, 3S-10.5 and up
Shaft Dimensions: 3.2mm (1/8") x 15.3mm
Weight: 5.6oz (158g)
Motor Diameter: 1.40" (35.85mm)
Motor Length: 1.9" (48.5mm)
Bearing Dimensions: Front: 4x13x5mm / Rear: 1/8x3/8x5/32"
Rotor Size: 12.5mm

jxs 01/21/16


Manufacturer Contact Information