Great Planes ElectriFly C-7 Nano Brushed ESC w/BEC

Tower Stock# LXKBF2  •  Manufacturer Stock# GPMM2005
Great Planes ElectriFly C-7 Nano Brushed ESC w/BEC (large view)
Regularly Purchased Together
Although customers also purchased these, compatibility is not guaranteed. Click an item for product details.

Notes from our tech department:
This is the C-7 Nano High Frequency Electronic Speed Control w/BEC.
For very small indoor, Park and Backyard Flyers with 280-size or
smaller Brushed motors requiring 7A or less.


Extremely compact size to minimize weight and simplify installation
Set battery type with included jumpers
Uses "Safe-Start" system to prevent accidental motor starts by
disabling the motor circuitry until the throttle stick is moved to
full throttle, then to the OFF position
Factory installed motor, radio and battery connectors
Fully proportional forward only (no brake)
Battery Eliminator Circuitry provides sufficient voltage for the
receiver and two to three micro servos. The motor battery powers
the receiver and servos, then when voltage is reduced to the
appropriate voltage, the Low Voltage cut-off circuitry stops the
motor while continuing to supply power to the receiver and servos
High frequency to optimize battery run-time and cool operation
Bright Blue LED and audible tones for easy set-up
Very smooth throttle response
180 day limited warranty


One C-7 Nano Electronic Speed Control with polarized micro
connector for battery, 2mm gold plated female bullet motor
connectors and Universal receiver connector and separate pre-
assembled leads with male and female 2-pin connectors
One instruction sheet


Attaching to motor and setting up speed control
Battery pack
Plug Universal plug into the throttle channel on the receiver


Length: .66" (17mm)
Height: .28" (7mm)
Width: .43" (11mm)
Weight: .20oz (5.5g) with wires
Input: 6-8 NiCd/NiMH cells; 2-3 LiPo cells
Max Rated Current: 7A continuous
BEC Voltage: 5V/1A
Low Voltage Cutoff: .80V per cell for NiCd/NiMH
2.75V per cell for LiPo
Connectors: Receiver lead- Universal
Battery lead- 2R micro connector
Motor Connector- 2mm gold plated female bullet connectors
Switching Frequency: 2.5kHz
Motor Size: 280 or less Brushed only


Will handle 3 micro servos with proper cooling
Do NOT use with Brushless motors

jxs 6/13/05
EEW 7/19/05
updated tlc 3/7/16

Manufacturer Product Web Page
Manufacturer Mailing Address
Additional Manufacturer Contact Info