Futaba S148 Standard Precision Servo

Tower Stock# FUTM0710  •  Manufacturer Stock# S148
  • Thumbnail 1 (see larger view)
  • Thumbnail 5 (see larger view)
Notes from our tech department:
The S148 Standard Servo yields increased power and speed with a reduced size
and weight compared to the S128, yet uses the same gears and servo cases.
This servo is a replacement for the following servos.(S6,S17,S18,S23,S26,S28

This servo can produce high-current draw from your batteries.
If using NiMH or LiPo batteries, make sure they are capable
of delivering sufficient amps.


One S148 Standard Precision Servo wJ connector and metal top
One accessory package with round rubber grommets, brass eyelets,
mounting screws, round and star shaped servo horn
Nylon gears
One year limited warranty through the Futaba USA Service Center
beginning at date of purchase


Control system: Pulse width control, 1.52ms neutral
Motor: 3-pole
Power requirement: 4.8V or 6V (from receiver)
Power consumption: 6V 8mA (at idle)
Torque: 33 oz-in (2.4 kg-cm) 4.8V
42 oz-in (3.0 kg-cm) 6V
Transit Time: 0.28 sec60 4.8V
0.22 sec60 6V
Dimensions: 1.6 x 0.8 x 1.4 (1-916 x 1316 x 1-716)
(40 x 20 x 36mm)
Weight: 1.6oz (1-916oz) (44g)
Mounting on-center dimensions
Width: .4
Length: 1.9
Shaft Diameter: 5.88mm
updt jxs 102903
updated mcw 51904
updt jxs 102904
updated jpg 102407
Updated JAW 112707


Manufacturer Contact Information

Futaba is a registered trademark of Futaba Corporation.