Tekno RC 1/10 SCT410 4WD Short Course Truck EP Kit

Tower Stock# LXDAHZ  •  Manufacturer Stock# TKR5500
Notes from our tech department:
This is the Radio Controlled, Electric Powered, 1/10 scale
SCT410 4x4 Short Course Truck Kit from Tekno RC.


Chassis: CNC aluminum 0.16" (4mm) thick, anodized black in color
with short front and rear overhang for better bump handling and
jump landing, adjustable front, center, and rear chassis braces for
fine tuning flex
Drive: Four wheel shaft drive with CVDs with captured pins
Motor Mount: Two-piece CNC aluminum with dual clamping gear mesh
Differentials: Bevel gear
Bumpers: Front and rear
Shocks: Oil-filled 16mm bore hard anodized with conical piston design
for varied compression and rebound rates, 4mm diameter steel shafts
Shock Towers: CNC aluminum 0.16" (4mm) thick
Suspension: Adjustable long travel design with adjustable length rear
arms, and adjustable front arm sweep and angle, front and rear sway
Steering: Ball bearing supported, narrow pivot posts, adjustable
bump-steer and Ackerman, Ackerman describes the effect of the
inside front wheel turning faster than the outside front wheel
during turns
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to
the chassis
Camber: Adjustable front and rear, camber refers to the angle of the
tops of the tires from vertical when viewed from front or behind
Battery Tray: 2.0x5.8" (50x148mm)


SCT410 4x4 Kit with Shocks, Shock and Diff Oil, Decals and


Radio: 2-channel with high torque steering servo
Motor: Short course brushless
Pinion Gear: 11-30 tooth Tekno RC MOD1 TKR4171-TKR4190 recommended
OR Tekno RC Traktion Drive/Electri-Clutch System
Electronic Speed Control: Compatible with selected motor
Battery: 2S LiPo
Battery Charger: Compatible with selected battery
Body: 1/10 scale short course
Wheels: Short course type with 12mm hex
Tires: Short course
Building and track equipment


Length: 20.87" (530mm)
Width: 11.65" (296mm)
Wheelbase: 12.7-13.2" (323-335mm)
Weight: 6.6lbs (3000g) ready to run, approximately
Differential Ratio: F/R 10-40t, center 44t


For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
6 8x16mm Fr, R & Ctr Diff 3 DTXC1585
2 5x11mm Front Gearbox 1 DTXC1547
2 5x11mm Rear Gearbox 1 DTXC1547
2 10x15mm Rear Hubs 1 DTXC1595
2 6x12mm Rear Hubs 1 DTXC1569
2 10x15mm Front Hubs 1 DTXC1595
2 6x12mm Front Hubs 1 DTXC1569
4 6x10mm Steering 2 DTXC1561

jxs 01/29/13



Manufacturer Contact Information