Futaba 6JA 6-Channel S-FHSS/4 S3004 Servos

Tower Stock# LXAVSW  •  Manufacturer Stock# FUTK6001
  • Thumbnail 1 (see larger view)
  • Thumbnail 5 (see larger view)
  • Thumbnail 6 (see larger view)
Tech Notices:Notice 1
Easy Pay
Request 3 Payments ($66.67, $66.66, $66.66) Details
Notes from our tech department:
This is the Futaba 6JA 6-Channel 2.4GHz
S-FHSS and FHSS Selectable Mode Radio System
with the R2006GS Receiver and four S3004 Servos.
The 6J transmitter is full range.
Only available in Mode 2.

This is the airplane version with the ratcheted throttle stick.


Selectable S-FHSS and FHSS modes, the included R2006GS receiver
automatically adapts to the selected mode
Capable of 4 channels only in FHSS mode
Fail safe on all channels in S-FHSS mode only (throttle channel only
when FHSS mode is selected)
15 model memory with 4 character model naming
40x40 127 segment LCD display
Modes 1-4 selectable by pilot
R2006GS high-voltage (4.8 - 7.4V) 6-channel receiver with Easy-Link
circuitry, frequency hopping, spread spectrum design and Dual
Antenna Diversity
Endpoint adjustment (EPA), sub trims, servo reversing & throttle cut
Throttle position, mix and low battery warnings
Trainer system (trainer cord not included)
One year limited warranty through Futaba USA beginning at date of
Airplane Features
Two programmable mixes and two 5-point throttle curves
Two 5-point pitch curves
Flaperon with differential rate
Flap trim (2 rates)
V-tail mixing
Elevon mixing
Helicopter Features
Two 5-point throttle curves
Three 5-point pitch curves
Throttle hold
Hover pitch
Gyro and revo mixing
Four swash plate types (H1, H3, HR3 & H3 wAFR)
Swash AFR (ailelepitch)
Throttle mix
Electronic swash ring
Throttle and pitch delay


Futaba 6J 6-Channel Transmitter, R2006GS Receiver and Instruction
Manual, Neckstrap, Servo Tray and Mounting Hardware, OnOff Switch
and ratchet spring
Four S3004 Standard Ball Bearing Servos, FUTM0004


AA Cells: Four for transmitter


Type: 2-stick, 6-channel, FHSSS-FHSS selectable
Frame Rate: 6.8ms
Current Drain: 170mA

Modes: FHSS or S-FHSS (auto selectable)
Power Requirements: 4.8V-7.4V
Compatible Batteries: NiCd, NiMH, LiPo, LiIon & LiFe
Dimensions: 1-1116 x 1516 x 516 (43 x 24 x 7.9mm)
Weight: 0.29oz (8.3g)
Current Drain: 80mA ( no signal)

S3004 Servo
Speed: 0.23 sec60 4.8V
0.19 sec60 6.0V
Torque: 44 oz-in (3.2 kg-cm) at 4.8V
57 oz-in (4.1 kg-cm) at 6.0V
Dimensions: 1.6 x 0.8 x 1.4 (1-916 x 1316 x 1-716)
(40 x 20 x 36mm)
Weight: 1.3 ounce (1-516oz) (37 grams)
Connector: J type with approx. 5 wire

jxs 022811
updt jxs 120511
updt jpg 22513
JMLM 112814



Product Documents & Files

Manufacturer Contact Information

Futaba is a registered trademark of Futaba Corporation.