This is the S3152 Digital Servo w/Ball Bearings for|
airplane, car and boat Use and Comes with "J" Connector Pre-Installed.
Comes with Heavy Duty wiring that can handle Higher Current Loads
Ball Bearing Output Shaft
Great for 1/8 Cars or Boats Where Higher Torque and Speed are Needed
One year limited warranty through the Futaba USA Service Center
beginning at date of purchase
One Digital High Torque Servo w/Small Round Horn and 11.5" (292mm)
Four Rectangular Grommets
Four Chrome Bushings
Four Mounting Screws
One Large Round Horn
One Six Arm Horn
One Four Arm Horn
Speed: .22 sec/60° @ 4.8V
.18 sec/60° @ 6V
Torque: 70 oz-in @ 4.8V
87 oz-in @ 6V
Weight: 1.5oz (41g)
Dimensions: 1.6 x 0.8 x 1.5" (40 x 20 x 38mm)
For a replacement gear set, order FUTM3328
S3152 Digital Servo Precautions,
-It is best to avoid long leads and Y-harnesses especially with
standard grade wires. If problems are encountered, consider using
heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
Pro Series, minimizing lead lengths, and/or removing Y-harnesses.
-Current Drain: Futaba S3152 Servo is Specially Designed for High-
Torque and High-Speed, Therefore Very High Current Drain Is Normal
At Startup. For Ultimate Performance When Using This Servo
Please Review The Following Points.
(1) When Using Systems With the Battery Fail Safe Function it Has
a Higher Cut-Off Voltage Setting Which Will Cause Shorter
(2) When Installing the Servo Please Check Pushrod Linkage To Make
Sure There Is No Binding in Order To Prevent Excessive Power
Consumption and Decrease the Life of the Motor and Battery.
This digital servo cannot be used with the following * AM *
transmitters as the servo neutral signal is: 1310us).
CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terratop,
T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.
***** Do not use digital servos with older AM systems *****
updated jpg 1/4/07