Futaba S148 Standard Precision Servo

Tower Stock# FUTM0710  •  Manufacturer Stock# S148
  • Thumbnail 1 (see larger view)
  • Thumbnail 5 (see larger view)
Notes from our tech department:
The S148 Standard Servo yields increased power and speed with a reduced size
and weight compared to the S128, yet uses the same gears and servo cases.
This servo is a replacement for the following servos.(S6,S17,S18,S23,S26,S28
S38,S128)

This servo can produce high-current draw from your batteries.
If using NiMH or LiPo batteries, make sure they are capable
of delivering sufficient amps.

INCLUDES

One S148 Standard Precision Servo w/"J" connector and metal top
bushing
One accessory package with round rubber grommets, brass eyelets,
mounting screws, round and star shaped servo horn
Nylon gears
One year limited warranty through the Futaba USA Service Center
beginning at date of purchase

SPECIFICATIONS

Control system: Pulse width control, 1.52ms neutral
Motor: 3-pole
Power requirement: 4.8V or 6V (from receiver)
Power consumption: 6V 8mA (at idle)
Torque: 33 oz-in (2.4 kg-cm) @ 4.8V
42 oz-in (3.0 kg-cm) @ 6V
Transit Time: 0.28 sec/60 @ 4.8V
0.22 sec/60 @ 6V
Dimensions: 1.6 x 0.8 x 1.4" (1-9/16 x 13/16 x 1-7/16")
(40 x 20 x 36mm)
Weight: 1.6oz (1-9/16oz) (44g)
Mounting on-center dimensions
Width: .4"
Length: 1.9"
Shaft Diameter: 5.88mm
ir/jl
updt jxs 10/29/03
ir/jxs
updated mcw 5/19/04
updt jxs 10/29/04
updated jpg 10/24/07
Updated JAW 11/27/07

Resources
Manufacturer Mailing Address
Additional Manufacturer Contact Info

Futaba is a registered trademark of Futaba Corporation.