Multiplex Twin Star II Kit 56"

Tower Stock# LXKYH2  •  Manufacturer Stock# M214210
Multiplex Twin Star II Kit 56
Notes from our tech department:
This is the radio controlled, electric powered, almost ready to fly
Multiplex Twin Star II Airplane.
For Intermediate Modeler/Fliers.


Construction: Elapor foam
Wings: Two-piece foam with GRP tubular wing joiner
Radio Compartment: Easily accessible under wing
Motors: Two Multiplex Permax 6 volt 400 size with connector board
and cables
Landing Gear: None, model is intended for hand launches and belly
Aileron Control: Dual Servo
Hardware: Control horns, rods and all mounting hardware included
Motor Mount: Wing mounted plastic motor brackets


Elapor foam fuselage and wing halves, pushrods, two 400 size motors
with connector board and cables, two propellers and spinners
hardware package, tail section, decals, photo-illustrated


Speed Control: Electronic
Battery: 7 or 8-cell flat
Charger: Timed or peak
Radio: 4-Channel
Servos: Four micro (2-ailerons, 1-elevator, 1-rudder)
Two Servo Extensions 12" (305mm): For aileron servos
Y-Harness: For aileron servos
Building and Field Equipment: Medium CA glue, activator, tools


Wingspan: 56" (1420mm)
Wing Area: 665 sq in (43 sq dm)
Weight: 53 oz (1500g)
Wing Loading: 11.5 oz/sq ft (35 g/sq dm)
Length: 43" (1085mm)
Airfoil: Semi-symmetrical, high wing
Center of Gravity: 3.3" (85mm) from the wing's leading edge at the
fuselage sides.
Control Throws-
Ailerons: Up +0.71" (+18mm) & Down -0.39" (-10mm)
Elevator: Up +0.94" (+24mm) & Down -0.59" (-15mm)
Rudder: Right & Left 0.79" (20mm) each side


For Brushless Motor Upgrade Pack, order MPUG3210.

This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium CA glue used with
an activator is the only method of gluing recommended by the

jxs 9/15/05

Know Before You Fly
Easy RC: Airplanes
Manufacturer Mailing Address
Additional Manufacturer Contact Info